Washing Machine Not Filling with Water: What to Check
No water entering your washer? Check the tap, inlet hose filter, valve and water level sensor with this guide.
If your washer starts but never takes water, work through this list.
1. Water supply
- Is the tap fully open?
- Is the water supply on? In some areas supply timing or low pressure is the issue
- Is the supply hose kinked?
2. Inlet hose filter
A small mesh filter sits where the hose connects to the machine. Sand and rust block it, especially in areas with hard or dirty water. Fix: Close the tap, unscrew the hose, pull out the mesh and rinse it.
3. Water inlet valve
This electrically controlled valve opens to let water in. Mineral buildup or a burnt solenoid coil prevents it from opening. If the machine hums but there's no water, suspect the valve. It is a common and relatively simple part to replace.
4. Door or lid switch
Some machines do not fill unless the door is detected as closed.
5. Water level / pressure sensor
A faulty sensor can think the drum is already full. The tube that connects the sensor to the tub can also be clogged or loose.
6. Control board
If the board does not send power to the inlet valve, it needs inspection. See washing machine PCB faults.
Fills slowly?
Often low water pressure or a partly blocked inlet filter.
Fills non-stop?
A stuck inlet valve or faulty level sensor can overfill and flood. Turn off the tap and the power at once.
Prevention
- Clean the inlet filters twice a year
- Use a water filter if the supply is gritty
Roman Urdu mein khulasa: Pani na aaye to nal, inlet hose ka filter aur inlet valve check karein. Phir level sensor aur board ka masla ho sakta hai.